Magnum Energy MS-PAE Series Owner's Manual download pdf (Page 7)

Page 1

1.0 Introduction

Congratulations on your purchase of the MS-PAE Series inverter/charger from Magnum Energy.

The MS-PAE Series is a “pure” sine wave inverter designed to provide 120 and 240VAC in a single

unit to power loads when inverting and also while charging. It has two 120VAC lines (L1 and L2), a

neutral and a ground. The two 120VAC output lines are 180° out-of-phase with each other, so that

the combination of the L1 and L2 lines total 240VAC and the voltage between either L1 or L2 and

neutral is 120VAC. The MS-PAE Series charger can accept 120VAC input (to L1 or L2) or 120/240

VAC split-phase input power (to L1 and L2), the incoming AC power is shared with the charger and

the output continues to be 120/240VAC with either a 120VAC or a 120/240VAC input.

When the power requirements of the system are beyond the capacity of a single MS-PAE Series

inverter or the system is expanded as more loads are added, up to four MS-PAE Series inverters

can be connected together in a parallel con¿ guration. Connecting inverters in parallel increases the

overall inverter power and surge capacity to power a large single load or several smaller loads.

Simply connect the inverter’s output to your distribution circuits or electrical panel; connect your

utility or generator power (AC) to the inverter’s easy-to-reach terminal block; connect the batter-

ies, and then switch on the power. Using optional remote controls (ME-RTR. ME-ARC or ME-RC),

you can easily operate and monitor your inverter from a remote location.

The MS-PAE Series Inverter/Charger includes the following:

• High wattage output in a small footprint - less weight and area needed for install.

• Ability to parallel up to four identical MS-PAE inverters to increase output power capability

(requires ME-RTR).

Pure sine wave output (<5% THD).

• 120/240 VAC Split phase output in a single inverter.

• PFC (Power Factor Corrected) multi-stage battery charger.

• RS485 standard communication protocol.

• Remote and Network ports (easy connection for optional accessories).

• ON/OFF Inverter-mounted switch with LED indicator.

• Large AC access and terminal block [wire size: #18 to #2 AWG (0.82 to 33.6 mm

) CU].

• DC terminal covers with 360 degree connection.

• Battery Temperature Sensor - for optimum charging during extreme temperature changes.

• Field Serviceable for quali¿ ed personnel - tested repair kits available.

• Smooth, aesthetically pleasing design.

• MS4024PAE and MS4448PAE are ETL listed to UL/cUL STD 1741 and CSA STD 22.2 107.01-

01 for safety.

The following accessories are also available for MS-PAE Series products:

ME-RTR (Router Control Panel) - uses a four-line LCD display to provide operating infor-

mation and setup/troubleshooting capabilities for multiple Magnum inverters. Provides four

ports that allow MS-PAE models to be connected in a parallel con¿ guration to increase output

power capacity.

ME-ARC (Advanced Remote Control Panel) - uses a two-line LCD display to allow advance

inverter setup, control and troubleshooting.

ME-RC (Standard Remote Control Panel) - uses two-line LCD display to allow standard

inverter setup, control and troubleshooting.

ME-AGS-N (Automatic Generator Start Module/Network version) - automatically starts/

stops your generator.

ME-BMK (Battery Monitor Kit) - provides precise DC voltage/current measurements and

provides information on your battery’s State of Charge (SOC) condition.

•

Introduction

1 2 3 4 5 6 7 8 9 10 11 12 ... 54 55

Comments to this Manuals

No comments

Magnum Energy MS-PAE Series Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Power adapters & inverters Magnum Energy MS-PAE Series